inmotionnero.blogg.se - My laptop shuts down when i log into phoenix viewer

My laptop shuts down when i log into phoenix viewer install#
My laptop shuts down when i log into phoenix viewer windows 10#
My laptop shuts down when i log into phoenix viewer plus#

To cut a long story short: if Windows has a problem with the BCD store, your will get problems with hibernation/sleep/hybrid shutdown. Created a new BCD store and after that, my hibernation / "hybrid shutdown" problems were gone. I deleted the "simple FAT32" partition, created an "ESP/UEFI" partition instead. This also seems to affect the configuration of power states (hibernation, sleep). But Windows could not access (find) the BCD store, because the partition did not have the required identifier.

It's a bit strange that the system did boot with this setup. After some more research I discovered that the EFI partition must be of a certain partition type: ĭuring the migration I had created a "simple FAT32" partition. Then I started comparing the boot environment of the system I had copied the EFI boot files and my migrated system. Google'ing what could be the reason for an inaccessible BCD did not give me any useful result. This seemed weird to me, I knew that I had created the BCD store after the migration and without the BCD store the system would not be able to boot. When trying any bcdedit operations I got an error message, that the BCD store could not be accessed.

I tried this guide: Switch RAID to AHCI without reinstalling Windows 10. All these steps had been performed while I was running Win10 PE from a special USB stick (c't emergency windows usb stick ).Īfter the migration the system was booting normally, but suffered from the same problems described by the OP.īecause I was using a SSD now, I also wanted to change the SATA access mode from RAID to AHCI. Then had I created a new BCD store with the required entires. To achieve that I created a new FAT32 partition (so called EFI/ESP partition) and copied the required files from another system running GPT/UEFI. During the migration I also changed the boot mechanism from MBR/classic to GPT/UEFI. I had the same problem, after I had migrated my OS from a hard drive to a SSD.

32GB 3200Mhz CL16 Kingston Hyper-X Predator.

My laptop shuts down when i log into phoenix viewer plus#

MSI X470 Gaming Plus Max (UEFI Boot Mode)."User-mode process attempted to change the system state by calling SetSuspendState or SetSystemPowerState APIs." (Information / Source: Kernel-Power) The event log shows only this message afterwards: Complete shutdown works fine but hibernate / sleep just gets me to the login screen after a few seconds of black screen. Go to hibernate / sleep via power button and start menu optionīehavior is always the same.Run the Windows power troubleshooting tool.Disable and re-enable hibernate option in boot menu.Disable wakeup for all devices with powercfg (keyboard, mouse, LAN controller).

My laptop shuts down when i log into phoenix viewer install#

Install latest drivers and BIOS firmware.

My laptop shuts down when i log into phoenix viewer windows 10#

Install latest Windows 10 updates (Build 1903).

I tried leaving it alone for 5 minutes but that didn't change anything. New hardware, fresh Windows 10 installation but when I try to put my computer to sleep or hibernate, the screen just goes black for a while and when I move the mouse or press a keyboard button it comes back showing the login screen.